Signs Your Pool Has a Leak and What to Do About It in Arizona

Signs Your Pool Has a Leak and What to Do About It in Arizona

If you own a pool in Phoenix, you already know that water disappears fast during summer. Between 110-degree days, single-digit humidity, and hot wind rolling across the surface, a typical Arizona pool can lose a quarter inch to half an inch of water per day just from evaporation. Over a full year, that adds up to four to six feet of water gone without a single crack or broken pipe involved.

So when you notice the water level dropping, the real question isn’t whether you’re losing water. You are. The question is whether you’re losing more than you should be. Knowing the difference between normal evaporation and an actual pool leak can save you hundreds of dollars in wasted water bills or thousands in structural damage that gets worse the longer it goes undetected.

How Much Water Loss Is Normal in Arizona?

During peak summer in the Phoenix metro, expect to add water to your pool at least once a week. A quarter inch of loss per day is completely normal for a pool in direct sunlight with no cover. If you run water features like spillovers, bubblers, or deck jets, you’ll lose even more because moving water exposes more surface area to that dry desert air.

Here’s what falls within normal range and what should get your attention. Losing up to half an inch per day during June through September with water features running is typical. One to two inches per week during cooler months from October through March is also expected. But if you’re consistently losing more than half an inch per day, or if the water level drops noticeably overnight when evaporation essentially stops, that’s when the math stops adding up. Water loss that stays constant regardless of temperature, humidity, or whether the pool is covered points toward a leak rather than evaporation.

The Bucket Test: A Free Way to Know for Sure

Before you call anyone, try this. Fill a bucket with pool water and set it on the top step of your pool so the water inside the bucket is exposed to the same sun, wind, and temperature as the pool itself. Mark the water level inside the bucket and the water level of the pool on the outside of the bucket. Wait 24 hours. If the pool has lost more water than the bucket, the difference is likely a leak. If both dropped by the same amount, you’re dealing with normal evaporation.

Run the test twice, once with the pump on and once with the pump off. If the pool loses water faster with the pump running, the leak is probably in the plumbing or equipment. If it loses water at the same rate regardless, the leak is more likely in the pool shell itself, around the skimmer, returns, or light fittings.

Where Arizona Pools Leak Most Often

Pool leaks aren’t random. They tend to show up in the same places, and Arizona’s conditions make some of these worse than they’d be in other climates.

The joint where the skimmer meets the concrete pool wall is the single most common leak location. Arizona’s soil shifts and settles constantly, especially in areas with expansive clay. That movement puts stress on the connection point between the plastic skimmer body and the gunite shell, and over time, small separations develop. You can sometimes spot these by looking into the skimmer and checking for cracks where the plaster meets the skimmer throat.

Equipment pad connections are another frequent source. The pipes running from the pool to your pump, filter, and heater have threaded fittings and glued joints that can loosen or crack. Arizona’s extreme temperature swings, from 115 degrees in the afternoon to 85 at night, cause PVC to expand and contract repeatedly. Over years, that cycling weakens joints. Check for wet spots, mineral deposits, or erosion around the base of your equipment pad.

Return fittings and pool lights round out the usual suspects. The gaskets around return jets and light niches degrade over time, and Arizona’s hard water accelerates that process. Calcium scale builds up around these fittings and can mask small leaks until they become bigger problems. If your water level consistently stabilizes right at the bottom of a return jet or at the top of your light niche, that’s a strong clue.

What a Leak Costs You if You Ignore It

A small leak might only waste a few hundred gallons a week, which shows up as maybe $10-15 extra on your water bill. Easy to ignore. But water doesn’t just disappear. It goes somewhere, and in Arizona that somewhere is usually into the soil around your pool’s foundation.

Saturated soil around a pool shell causes settling, which causes deck cracking, which causes more settling. A leak that costs $200 to fix today can turn into a $2,000 deck repair in six months if the water undermines the soil beneath the coping. Underground plumbing leaks are even worse because the water erodes soil along the pipe trench, eventually creating voids that compromise the structural support around the pool.

Your water chemistry suffers too. Constantly adding fresh Phoenix tap water means constantly adding calcium, and our tap water runs 15 to 25 grains per gallon. Every gallon of makeup water raises your calcium hardness, which accelerates scale buildup on your tile, equipment, and salt cell if you have one. You end up needing a drain and refill sooner than you otherwise would.

When to DIY and When to Call a Pro

If the bucket test confirms a leak and you can see the source, like a dripping pump union, a cracked fitting on the equipment pad, or a visible separation at the skimmer, some of these are straightforward fixes. A pump union needs tightening or a new o-ring. A skimmer separation can sometimes be sealed with pool putty as a temporary measure.

But if you can’t see where the water is going, that’s when professional leak detection is worth the money. Leak detection specialists use pressure testing on your plumbing lines and acoustic listening equipment to pinpoint leaks underground or behind the pool shell without tearing up your deck. The cost of a professional leak detection typically runs $400 to $750 depending on complexity, and it’s almost always cheaper than guessing and digging in the wrong spot.

Keep an Eye on It Before Summer Hits

The worst time to discover a leak is mid-July when your pool is losing water from both evaporation and a crack you didn’t know about. If you’ve noticed your autofill running more than usual, if you’re adding water more than once a week, or if you see wet spots in your yard that weren’t there before, run the bucket test now while the weather is still manageable and leak detection companies aren’t slammed with emergency calls.

If you’re not sure whether your water loss is normal or something more, Picture Perfect Pool Services can take a look during a regular service visit and let you know what we’re seeing. We service pools across Phoenix, Scottsdale, Tempe, Mesa, Chandler, Gilbert, Paradise Valley, Ahwatukee, Surprise, and Queen Creek. Call or text 623-777-2155.

Leave a Comment

Your email address will not be published. Required fields are marked *